Discharge Chute; Deflector Remote - Ariens 926001-ST926LE Owner's/Operator's Manual

5. Loosen the top jam nut 1 – 3 turns.
6. Tighten the bottom jam nut.
7. Re-install bottom cover.
8. Check function of remote wheel lock. If wheel
lock does not function properly, take unit to
Dealer for repairs.
Finger tighten top jam nut, then
loosen top jam nut 1 – 3 turns.
3
1
2
No Slack
1. Top Jam Nut
2. Bottom Jam Nut
3. Cable Adjuster
Figure 24

DEFLECTOR REMOTE

Deflector must stay in selected position while throwing
snow.
If deflector does not stay in set position:
1. Tighten nut beneath control panel to increase
pressure on deflector control (Figure 25).
If deflector does not follow full range of travel:
1. Push deflector remote all the way forward.
2. Loosen adjusting nuts on cable support bracket
underneath the dash panel (Figure 25).
3. To adjust the deflector lower:
Slide cable down. Tighten bottom nut.
4. To adjust deflector higher:
Slide cable up. Tighten top nut.
5. Check travel and repeat adjustment as
necessary.
1

DISCHARGE CHUTE

OS7170
If chute does not stay in position while throwing snow
or if chute does not rotate freely, adjust the cable under
the control panel so the chute lock fingers engage or
disengage the locking gear.
If chute does not stay in position:
Loosen the cable by loosening the lower adjustment
nut, and then tightening the upper adjustment nut
against the bracket (Figure 26).
GB - 24
2
1. Adjusting Nuts
2. Cable Support Bracket
Figure 25
Figure 26
Tighten nut.
OS7175
Tighten upper
adjustment nut.
Loosen lower
adjustment nut.
OS7180