Preparations; Area Settings; Settings When Connecting With Only Single-Mode Optical Fiber Cable - Sony HXCU-FB70 Operating Instructions Manual

Hd camera control unit
Hide thumbs Also See for HXCU-FB70:
Table of Contents

Advertisement

Preparations

Area Settings

Before using the unit
When you use this unit for the first time, area setting is
required.
Setting the area
SW1, SW2 button
PANEL ACTIVE button
LOCK switch
POWER switch
1
Turn the power on.
2
Set the LOCK switch to OFF and make sure that the
PANEL ACTIVE button is not illuminated.
If the PANEL ACTIVE button lights up, press the button to
turn the light off.
3
Press and hold down the SW1 and SW2 buttons at the
same time for more than two seconds.
The unit switches to setting mode and selectable setting
values appear in the SHUTTER display.
4
Release the buttons after the unit switches to setting
mode.
5
Select the desired area, using the UP/DOWN lever,
within five seconds after the unit switches to setting
mode.
Settings
Areas
60i5
NTSC (except Japan)
b)
60i
NTSC (Japan)
c)
50i
PAL
a) NTSC composite video signal output with a black setup (7.5 IRE).
System frequency: 59.94i
b) NTSC composite video signal output with no black setup. System
frequency: 59.94i
c) PAL composite video signal output. System frequency: 50i
Note
The setting mode is deactivated unless setting starts within five
seconds after the unit switches to setting mode. Follow step 3
again to activate setting mode.
SHUTTER display
UP/DOWN lever
a)
"- - - - " appears in the SHUTTER display five seconds after
setting. Area settings are stored and the units switches to
normal mode.
Settings when Connecting with Only
Single-Mode Optical Fiber Cable
LASER DIODE (optical output) setting
When you use only single-mode optical fiber cable to connect
the HD camera adaptor to this unit, configure the optical output
setting in the unit.
Setting LASER DIODE
1
Connect the unit and the HD camera adaptor by a
single-mode optical fiber cable.
2
Set the POWER switch of this unit to ON.
3
Display the menu.
For information on the menu setting, see "Setup Menu" on
page 18.
4
Set the optical output to ON.
Display the <OUTPUT SELECT>S01 page on SYSTEM
OPERATION menu, then set LASER DIODE to ON.
Notes
• This setting is unnecessary when you use optical composite cables.
• In the factory default setting, LASER DIODE is set to OFF when this
unit starts up. If you want to retain the LASER DIODE setting you
have previously set, from the CCU CONFIGURATION menu, select
<OTHERS> C12 page, LASER DIODE BACKUP, then set to
ENABLE.
• Use general, single-mode optical fiber cables with an LC connector
for connection. For details, please contact a Sony sales
representative.
9
Preparations

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents