Standard Equipment; Inspecting The Pressing Tool And Jaw Sets; Compact 100-B Battery Charger; Attaching Pressing Jaws - RIDGID Compact 100-B Operator's Manual

Compact 100-B Pressing Tool

Standard Equipment

Catalog
No. Description
16953 Compact 100-B Pressing Tool with
(2) Ni-MH Batteries, Charger (115V),
1 / 3 / ", 1" ProPress
",
2 4
for Copper Tubing, Carrying Case
16988 Compact 100-B Pressing Tool with
(2) Ni-MH Batteries, Charger (115V),
1 / ", 3 / ", 1" PureFlow™ Compact Jaw Sets
2 4
for PEX Tubing, Carrying Case
16948 Compact 100-B Pressing Tool with
Carrying Case
Inspecting The Compact
Pressing Tool and Jaw Sets
WARNING
To prevent serious injury, inspect the Compact
100-B Pressing Tool, battery charger and Compact
Jaw Sets. Never use the Compact 100-B Jaw Set
with damaged or missing parts. The following
inspection procedures should be performed on a
daily basis:
1. Make sure the Compact 100-B Pressing Tool battery
is removed.
2. Inspect the tool housing and switch for damage.
Check for damage such as cracks in the tool housing
and exposed wires.
3. Inspect the jaw sets. If dirty, clean jaw sets. Refer to
Maintenance Section for cleaning instructions. Failure
to properly maintain jaws can result in an improper
connection that can lead to extensive property dam-
age. If any cracks are found, discard the damaged
assemblies and obtain replacement.
Always discard the entire assembly. Never
WARNING
replace individual components except for jaw return
springs. Failure to replace the entire assembly may result
in component failure and serious injury.
4. Clean any oil, grease or dirt from the tool handles.
This reduces the risk of the tool slipping from your grip.

Compact 100-B Battery Charger

Inspect the power cord and plug for damage. If the cord or
plug is damaged, do not use the charger until the cord is
Weight
25.4 lbs.
(11,5 kg.)
® Compact Jaw Sets
25.4 lbs.
(11,5 kg.)
12.0 lbs
(5.5 kg)
Ridge Tool Company
replaced. Inspect charger for damage. Do not use charg-
er if it has received a sharp blow, been dropped or oth-
erwise damaged.

Attaching Pressing Jaws

CAUTION Only use RIDGID Jaw Sets. Use with the
RIDGID jaw set intended for the specific fitting system and
tubing material you are installing. Use of other jaw sets will
result in an improper seal that could result in extensive
property damage.
1. Make sure the battery is removed.
2. Pull the jaw set mounting pin to its most open position
(Figure 2).
Figure 2 – Pulling The Jaw Set Mounting Pin Out
3. If pressing tool contains a jaw set, slide it out of the
pressing tool.
Figure 3 – Sliding Jaw Set Into Compact 100-B
4. Select the jaw set that corresponds to the tubing
size and fitting system. Inspect the jaw set. If dirty,
clean jaw sets. Refer to Maintenance Section for
cleaning instructions.
WARNING Failure to clean jaws can result in an im-
proper connection that can lead to extensive property
damage. If any cracks are found, discard the damaged
jaw set and obtain replacement.
5