Installation - Life Fitness LCD Entertainment Ready Installation Instructions Manual

I
NSTALLATION
Note to the CATV Installer:
This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides
guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the ground-
ing system of the building as close to the point of cable entry as practical.
Antenna Grounding According to the NEC
Antenna Grounding According to the National Electrical Code, ANSI/NFPA 70.
1. Antenna lead in wire
2. Antenna discharge unit (NEC Section 810-20)
3. Grounding conductors (NEC Section 810-21)
4. Ground clamp
5. Power service grounding electrode system (NEC Article 250, Part H)
6. Ground clamp
7. Electric service equipment
R C C
EMOTE ONTROL ONFIGURATION
T R : Metric Allen Set
OOLS EQUIRED
Mount the PIVOT DISC (A) and FRONT BRACKET (B) to the back of the REMOTE CONTROL (C) using
one SCREW (D). Leave the SCREW loose at this time.
Select a user accessible location to mount the REMOTE CONTROL. Position the remote with
bracket at the desired location. Pivot the remote as necessary for optimal user access.
NOTE: If the desired location is such that the BRACKET will not work for mounting,
remove the FRONT BRACKET and reinstall the PIVOT DISC. The remote can now
be installed using the two CABLE TIES (E) or FASTENER DISCS provided with the
REMOTE. Be sure the PIVOT DISC is oriented to accomodate the mounting sur-
face.
Tighten the screw to secure the PIVOT DISC and FRONT BRACKET to the
remote.
Reposition the REMOTE with BRACKET in the desired location and secure the
REMOTE to the equipment using the REAR BRACKET (F) and two SCREWS (G).
Tighten the SCREWS securely.
NOTE: Two differing length of SCREWS (G) are included to accomodate various mounting thicknesses.
NOTE: The REMOTE CABLE (H) can be routed through any of two cable routing channels in the back of the REMOTE or around the
PIVOT DISC.
Recommended Remote Locations:
Product
95/97Ti Treadmill
90/91Ti Treadmill
90/93/95Xi Cross-Trainer
91X Cross-Trainer
95Li Summit Trainer
90/93/95Si Stairclimber
90/93/95Ci Upright Bike
90/93/95Ri Recumbent Bike
6
Location
Ergobar - far right side
Ergobar - far right side
Aft of water bottle tray - centered
Bullhorn near weld to console support tube
- near LEFT side
Handrail crossbar - near right of water tray
Handrail crossbar - near left of Polar cover
Modified Polar cover w/ holes for
cable ties - centered
Front bullhorn handle - right side
Attachment Method
Bracket direct to tube
Bracket direct to tube
Controller mounts to unique bracket
on monocolumn
Bracket direct to tube
Bracket direct to tube
Bracket direct to tube
Controller mounts to modified Polar
cover via cable ties
Bracket direct to tube