Switch & Receiver; Wing Attachment; Pilot - THUNDER TIGER TTR4550 Assembly Manual

Attach the cowl using the four 2.3x12mm self-tapping screws.
Trim the cowl using the included black and purple trim tape.
Note: Since the needle valve was not long
enough to extend outside the cowl, we had
to install an extension. Depending on the
engine you use this may be necessary. We
made ours out of the excess wire from the
throttle pushrod.
X. Switch and Receiver Installation
Set the switch plate against the left side of the fuselage and scribe
a line inside the switch plate with an Xacto knife. Remove the switch
plate and cut through the covering and balsa. We have placed our
switch against the black trim stripe to minimize its appearance.
Wrap the receiver and battery pack in foam padding and place
where necessary for proper balance. We secured our receiver to the
throttle servo tray and fitted our battery pack above the fuel tank.
receiver
17
SWITCH AND RECEIVER
X. Wing Attachment
With the fuselage upside down, connect the aileron servos to the
receiver and bolt the wing on.
Trim the belly pan with the enclosed purple trim tape.
XI. Pilot
If you choose to use the enclosed pilot, cut in half and trim off the
flashing from around the edges of his head. Glue both halves togeth-
er and mount onto torso and paint with modeling enamel.
We have chosen to use a 1/4 scale Cap'n Ed (ACE60K64).