Wing Assembly - THUNDER TIGER TTR4550 Assembly Manual

WING ASSEMBLY

I. Mount Servos
With the wing panel upside down, locate the servo well and cut an
X from corner to corner using an Xacto knife.
Use a sealing iron to tack down the covering inside the servo well.
With the wing rightside up, locate the servo wire exit hole and
remove covering.
Attach the 12" aileron extension lead to the servo.
Install the servo in the wing. Use a servo arm instead of the
standard wheel.
Use a piece of clear tape to temporarily hold the servo pigtail to the
wing to prevent it from slipping back into the wing while you are
working.
II. Install Ailerons
Remove the aileron and insert T-pins into the centers of the hinges.
Install aileron onto the wing, remove T-pins, and apply thin CA to the
hinges (both sides).
6