Grandstream Networks GXP1610 Administration Manual page 35

Host name (Option 12)
Vendor Class ID
(Option 60)
PPPoE Account ID
PPPoE Password
PPPoE Service Name
IPv4 Address
Subnet Mask
Gateway
DNS Server 1
DNS Server 2
Preferred DNS Server
IPv6 Address Type
Static IPv6 Address
IPv6 Prefix Length
IPv6 Prefix
DNS Server 1
DNS Server 2
Preferred DNS server
Network -> Advanced Settings
802.1X mode
802.1X Identity
MD5 Password
802.1X CA Certificate
802.1X Client Certificate
HTTP Proxy
HTTPS Proxy
Layer 3 QoS
Layer 2 QoS
802.1Q/VLAN Tag
Layer 2 QoS 802.1p
Priority Value
PC Port Mode
default, it is set to "DHCP".
Specifies the name of the client. This field is optional but may be required by
some Internet Service Providers.
Used by clients and servers to exchange vendor class ID.
Enter the PPPoE account ID.
Enter the PPPoE Password.
Enter the PPPoE Service Name.
Enter the IP address when static IP is used.
Enter the Subnet Mask when static IP is used for IPv4.
Enter the Default Gateway when static IP is used for IPv4.
Enter the DNS Server 1 when static IP is used for IPv4.
Enter the DNS Server 2 when static IP is used for IPv4.
Enter the Preferred DNS Server for IPv4.
Allows users to configure the appropriate network settings on the phone to
obtain IPv6 address. Users could select "Auto-configured" or "Statically
configured" for the IPv6 address type.
Enter the static IPv6 address when Full Static is used in "Statically configured"
IPv6 address type.
Enter the IPv6 prefix length when Full Static is used in "Statically configured"
IPv6 address type.
Enter the IPv6 Prefix (64 bits) when Prefix Static is used in "Statically
configured" IPv6 address type.
Enter the DNS Server 1 for IPv6.
Enter the DNS Server 2 for IPv6.
Enter the Preferred DNS Server for IPv6.
Allows the user to enable/disable 802.1X mode on the phone. The default
value is disabled. It can be set to EAP-MD5, EAP-TLS or EAP-
PEAPv0/MSCHAPv2.
Enter the Identity for the 802.1X mode.
Enter the MD5 Password for the 802.1X mode.
Upload 802.1X CA certificate to the phone; or delete existed 802.1X CA
certificate from the phone.
Upload 802.1X Client certificate to the phone; or delete existed 802.1X Client
certificate from the phone.
Specifies the HTTP proxy URL for the phone to send packets to. The proxy
server will act as an intermediary to route the packets to the destination.
Specifies the HTTPS proxy URL for the phone to send packets to. The proxy
server will act as an intermediary to route the packets to the destination.
Defines the Layer 3 QoS parameter. This value is used for IP Precedence,
Diff-Serv or MPLS. The default value is 12.
Assigns the VLAN Tag of the Layer 2 QoS packets. The default value is 0.
Assigns the priority value of the Layer2 QoS packets. The default value is 0.
Configures the PC port mode. When set to "Mirrored", the traffic in the LAN
port will go through PC port as well and packets can be captured by
GXP1610/GXP1620/GXP1625/GXP1628
Administration Guide
Page 34 of 48