Removing the hard disk drive for type 6270 and 6276
To replace or remove the hard disk drive, do the following:
1. Disconnect the power and signal cables from the diskette drive.
2. Lay the computer on the side to access the screws on the bottom. Remove
the two screws that secure the mounting tray at the bottom of the system unit.
3. Pull the drive mounting tray upward and remove it.
4. Remove the four screws (two on each side) that secure the hard disk drive to
the mounting tray.
5. Pull the hard disk drive from the mounting tray to remove it.
6. Reverse the precedure to install a drive.
Adding and removing adapter cards and drives
6-15