Table of Contents
Advertisement
Selecting the Heat Mode
You can select the Heat mode if you want to heat your room.
You can adjust the temperature and the fan speed when heating.
1
If necessary, press the
Result:
The operation indicator on the indoor unit lights up.
The air conditioner starts up in the mode you selected last.
The indoor unit beeps.
2
Press the
button on the remote control until
Result:
The indoor unit beeps each time you press the
The air conditioner runs in the Heat mode.
Note
You can change modes at any time.
3
Press the
button to adjust the temperature until the required
temperature is displayed.
You can set the temperature between 61°F(16°C) and 86°F(30°C).
Result:
E ach time you press the
- The temperature is adjusted by 1°F
- The indoor unit beeps
I f the room temperature reaches 9°F higher than the set
temperature, the air conditioner stops heating, but the fan
operates consistently.
I f the room temperature reaches 5°F lower than the set
temperature, the air conditioner starts heating again.
4
Press the
button to select the fan speed until the required settingis
displayed.
Automatic (rotated :
Low
Medium
High
Maximum
Result:
Each time you press the
F or the first 3~5 minutes, the fan may not operate to prevent
the cool air from running out of the indoor unit.
It helps to warm the air in your room sufficiently.
5
To control the airflow direction, refer to pages 16 and 17.
141 Kinderkamack Rd, Park Ridge, NJ 07656 Tel: 201-782-1782 Fax: 201-782-1783 Web: www.amgair.com Email: info@amgair.com
(On/Off) button.
is displayed.
button:
button, the indoor unit beeps.
Air Marketing Group LLC
button.
)
11
E-
Advertisement
Table of Contents
