Table of Contents
Advertisement
Troubleshooting Guide
Before contacting the service center, check the following. It will save your time and theexpense of an
unnecessary call.
The air conditioner does
not operate.
The air conditioner does not operate
with the remote control.
No beep is heard when you press
the
remote control.
The air conditioner does not
cool or heat.
When heating, the required
room temperature is never reached
and the air conditioner frequently
stops.
The fan speed does not change when
you press the
The airflow direction does not
change when you press
the
The timer is not correctly triggered.
Odor permeates into the room during
operation.
24
E-
141 Kinderkamack Rd, Park Ridge, NJ 07656 Tel: 201-782-1782 Fax: 201-782-1783 Web: www.amgair.com Email: info@amgair.com
Problem
(On/Off) button on the
button.
button.
Air Marketing Group LLC
Explanation/Solution
Check if the circuit breaker of the air conditioner is switched on.
Check if the air conditioner is turned on. If necessary,
press the
(On/Off) button on the remote control.
Check if the Timer indicator on the indoor unit is on.
If so:
- Wait until the set time is reached and the air conditioner starts
automatically.
- Cancel the Timer. (See pages 18 and 19 for further details)
Check if there are no obstacles in front of the indoor unit.
Check the remote control batteries.
Make sure that you are with in 7 meters from the indoor unit.
Check if you are pointing the remote control at the remote control
sensor on the right side of the indoor unit.
Replace the remote control batteries if necessary.
Check if the correct operating mode has been selected
(Auto, Cool, Heat).
The room temperature may be too low or too high.
Check if the air filter is dirty; refer to page 25 for cleaning
instructions.
Check that there is no obstacle in front of the outdoor unit.
Check if the required temperature is set correctly.
Increase the fan speed.
If the airflow is directed upwards, set the blade downwards with the
remote control.
Check if the mode is set to the Auto, Cool, Heat or Fan mode;
in the Dry mode, the fan speed changes automatically.
Check if the air conditioner has been turned on; if necessary,
press the
(On/Off) button on the remote control.
Check if the timer is set correctly; see pages 18 and 19.
You can use the Fan mode to ventilate your room.
Advertisement
Table of Contents
