Table of Contents
Advertisement
FIGURE 6
STEP 6:
• SECURELY assemble BACK PAD (14) to the RIGHT & LEFT PAD SUPPORTS (12) (13) using four 3/8 X 2-3/4" BOLTS (36)
and four 3/8" WASHERS (41) as shown in FIGURE 6.
FIGURE 7
49
24
55
9
STEP 7:
• Aseemble two ROLLER PADS (4) to the BENCH FRAME (7) using one 18-1/4" SHAFT (18), four PLASTIC WASHERS (24),
and two STARLOCK COLLARS (49) as shown in FIGURE 7.
• Assemble one 1-1/4" RUBBER BUMPER (28) to the middle of the plate on the BENCH FRAME (7) as shown on FIGURE 7.
•
Insert two 3/4" FLANGE BEARINGS (55) into the bushing of the LEG PEDESTAL (9), then slide the 3/4" DIA TAPPED SHAFT
(51) into the 3/4" FLANGE BEARINGS (55) as shown in FIGURE 7.
14
4
28
55
51
13 12
7
7
7
36 3/8 X 2-3/4"
41
18
4
24
49
Advertisement
Table of Contents
