Alert! Previous Attempts At Booting This System Have Failed At Checkpoint [Nnnn]. For Help In Resolving This Problem, Please Note This Checkpoint And Contact Dell Technical Support; Alert! Security Override Jumper Is Installed; Attachment Failed To Respond; Bad Command Or File Name - Dell OptiPlex 3010 Owner's Manual

Alert! Previous attempts at booting this system have failed at checkpoint [nnnn]. For help
in resolving this problem, please note this checkpoint and contact Dell Technical Support.
Description The computer failed to complete the boot routine three consecutive times for the same error. Contact Dell
and report the checkpoint code (nnnn) to the support technician

Alert! Security override Jumper is installed.

Description The MFG_MODE jumper has been set and AMT Management features are disabled until it is removed.

Attachment failed to respond

Description The floppy or hard drive controller cannot send data to the associated drive.

Bad command or file name

Description Ensure that you have spelled the command correctly, put spaces in the proper place, and used the
correct pathname.

Bad error-correction code (ECC) on disk read

Description The floppy or hard drive controller detected an uncorrectable read error.

Controller has failed

Description The hard drive or the associated controller is defective.

Data error

Description The floppy or hard drive cannot read the data. For the Windows operating system, run the chkdsk utility to
check the file structure of the floppy or hard drive. For any other operating system, run the appropriate
corresponding utility.

Decreasing available memory

Description One or more memory modules may be faulty or improperly seated. Re-install the memory modules and, if
necessary, replace them.
49