Making Various Settings; Assigning Functions To The Remote Control Unit; Assigning The Function To - Sony UP-55MD Instructions For Use Manual

To perform rough adjustment
To perform color balance adjustment beyond the
current color balance range, increase the value of
BAL STEP.
If you change BAL STEP from 05 to 10, the color
balances of the test print are changed as illustrated.
2
Make a test print by repeating steps 2, 3 and 4 in
"Adjusting the Color Balance" on page 57.
3
Select the image with the best color balance among
the 9 images, if you can decide.
If there is not the image with the best color balance,
repeat steps 1 and 2 until you have obtained the best
color balance.
4
Go back to step 6 in "Adjusting the Color Balance"
on page 57.
60

Making Various Settings

Making Various Settings
Assigning Functions to the Remote
Control Unit
You can control a printer using the RM-91 Remote
Control Unit (not supplied) or FS-24 Foot Switch (not
supplied) connected to the REMOTE 2 connector on the
rear panel of the printer.
Using the menu, you can assign the desired functions to
the remote control unit connected to the REMOTE 2
connector.
In addition, the printer can be remotely controlled by a
pulse signal input to REMOTE 2. (See page 66.)
Also, you can control the printer using a personal
computer.
1
Display the FUNCTION SETUP menu from the
PRINTER SETUP menu.
2
Select the desired RM 2 FUNC item, then assign a
function.
Function to be Operation
selected
CAPTURE Has the same function as the
CAPTURE button on the printer.
PRINT Has the same function as the
PRINT button on the printer.
a)
C & PRINT Captures an image to a memory
(CAPTURE & page where there is not a queued
PRINT) image waiting to be printed and
print them whenever you press
the switch. If you press the
switch while printing is being
performed, the selected image is
queued, with the queued image
being printed once printing has
been completed.