Erasing The Screen Display On The Video Monitor; Output Setup Erasing The Screen Display - Sony UP-55MD Instructions For Use Manual

Erasing the Screen
Display on the Video
Monitor
You can erase characters displayed on the video monitor
(Q1, A and so on) when, for example, it is hard to see the
image that is hidden behind the screen display. The
printer operation is the same, regardless of whether
those characters are displayed on the video monitor.
Since the same characters are displayed in the printer
window display, perform operations watching them in
the printer window display.
For detailed information on displaying remaining
amount of the ink ribbon, see "Displaying the
Remaining Amount of the Ink Ribbon" on page 62.
1, 2
1
Press the DISPLAY button.
The current setting appears. The video monitor
screen is reset to the regular screen after a few
seconds.
The currently selected setting is lit in green.
2
Select OFF.
While the screen which appears in step 1 is
displayed, press the DISPLAY button repeatedly
until the color of OFF turns green on the video
monitor, or until OFF is displayed in capital letters
in the printer window display.
Each time you press the DISPLAY button, the
setting changes in the following sequence: ON t
OFF t ON....
Highlight OFF in green.
To display characters on the video monitor
Select ON.
To perform the setting for the monitor display
on the menu
You can also set whether characters are displayed on the
video monitor by changing DISPLAY to ON or OFF in
the OUTPUT SETUP menu. The setting of the
DISPLAY button also changes according to the setting
of DISPLAY in the OUTPUT SETUP menu, and vice
versa.
When you want to see an image that is hidden
below a menu
You can erase the menu temporarily while holding the
DISPLAY button down.
Note
The error messages are always displayed regardless of
the setting of the monitor display.

Erasing the Screen Display on the Video Monitor

43