Making Various Settings; Assigning Functions To The Remote Control Unit - Sony UP-21MD Instructions For Use Manual

Making Various Settings

Assigning Functions to the Remote
Control Unit
You can control the printer using the RM-91 Remote
Control Unit (not supplied) connected to the REMOTE
2 connector on the rear panel of the printer.
Using the menu, you can assign the desired functions to
the remote control unit connected to the REMOTE 2
connector.
In addition, the printer can be remotely controlled by a
pulse signal input to REMOTE 2. (See page 59.)
Also, you can control the printer using a personal
computer.
For detailed information on controlling the printer with
a computer, contact with your Sony dealer.
1
Display the FUNCTION SETUP menu from the
PRINTER SETUP menu.
2
Select the timing to capture the image on the
IMMED. CAP. item
When you want to
Capture the image just after the trigger
pulse is input to the REMOTE 2
a)
connector.
Capture the image a certain interval
after the trigger pulse is input to the
REMOTE 2 connector.
a) When IMMED. CAP. is set to ON, display the source
image on the video monitor when sending the trigger
pulse to the printer. The printer operation is set only to
capture an image when receiving the trigger pulse.
b) For detailed information on the timing for the REMOTE
2 connector, see page 59.
Notes
• Select ON when you want to capture the image at
a precise point in time controlled from the
computer.
• To assign the function to the remote control unit
connected to the REMOTE 2 connector on the
52
Making Various Settings
Selection
ON
OFF
b)
FUNCTION SETUP menu, set the IMMED.CAP
item on the FUNCTION SETUP menu to OFF.
3
Select the desired RM 2 FUNC item, then assign a
function.
Function to be Operation
selected
CAPTURE Has the same function as the
CAPTURE button on the printer.
PRINT Has the same function as the
PRINT button on the printer.
a)
C & PRINT Captures an image to a memory
(CAPTURE & page where there is not a queued
PRINT) image waiting to be printed and
print them whenever you press
the switch. If you press the
switch while printing is being
performed, the selected image is
queued, with the queued image
being printed once printing has
been completed.
b)
CYCLIC-C Captures images to memory
(CYCLIC CAPTURE) pages where there are no queued
images. It does this cyclically
whenever you press the switch.
The printer continues to capture
images, replacing the one
previously captured with a new
one.
b)
CAP-STOP Captures images in a memory
(CAPTURE STOP) page whenever you press the
switch of the remote control unit.
Once images have been captured
in all the memory pages, the
printer stops capturing images
and the message HIT ANY KEY
appears.
STOP Stops printing after the current
printing operation is finished
whenever you press the switch of
the remote control unit.
CAP/SRC When the memory image is
(CAPTURE/ displayed, the source image
SOURCE) appears when you press the
switch.
When the source image is
displayed, the image is captured
in memory when you press the
switch of the remote control unit.
However, the memory page is not
changed. The previously
captured image is replaced with
the new one.