Samsung SNB-7000 User Manual page 52

setup screen
WDR Setup
It displays a sharp image of the objects in a scene where both bright and dark areas exist.
1. Select <Backlight>.
2. Set <Mode> to <WDR>.
3. Specify the <WDR level>.

M
WDR is available only if <Megapixel
Mode> is set to <2-Megapixel>.

If WDR mode is active, the shutter mode
cannot be changed. Data transfer via the
network is available at up to 15 fps.

If the WDR mode is active, a moving object can cause an afterimage on the screen.
Exposure Setup
You can adjust the exposure level of the camera.
1. Select <Exposure>.
2. Select each item and set it properly.
• Brightness : Adjust the screen
brightness.
• Shutter mode : Adjust the electronic
shutter of the camera.
- ESC (Electronic shutter control) :
Adjust the shutter speed
automatically according to the
ambient brightness.

This will be activated if <Lens> is set to
<Manual>.
- Manual : Adjust the shutter speed of the camera manually.
- A.FLK (Anti flicker) : This will prevent the screen from flickering.
• Shutter speed : Control the shutter speed manually.
• SSNR3 : Specify the use of noise reduction.
• SSNR3 level : Adjust the noise reduction level.
• Sens-up mode : Automatically senses the darkness level at night or in a low
contrast scene and extends the accumulation time accordingly for a bright and
sharp image.

If you set the shutter mode to Manual/A.FLK, SENS-UP mode will be deactivated.

The greater the video accumulation factor is, the brighter the screen is but the afterimage of a
moving object grows accordingly.
52_ setup screen