Samsung SNB-7000 User Manual page 14

overview
Item
System, Power,
SD Indicators
Reset Button
Power Port
GND
Network Port
I/O Port
Video Out Port

J
RS-485 port only supports direct connection with pan/tilt driver and external connections of the
RS-485 controller is not supported.
14_ overview
ON : While the power is on
POWER
OFF : If the power is off
Resets the camera settings to the default. Press and hold it for about 5
seconds to turn off the system indicator and restart the system.
J
If you reset the camera, the network settings will be adjusted so that
DHCP can be enabled. If there is no DHCP server in the network, you
must run the IP Installer program to change the basic network settings
such as IP address, Subnet mask, Gateway, etc., before you can
connect to the network.
Used to plug the power cable.
Used for earth-grounding.
Used to connect a PoE or LAN cable.
ALARM IN Used to connect the alarm input signal.
ALARM OUT Used to connect the alarm output signal.
ALARM COM Common port where the alarm output signal is connected.
GND Used for earth-grounding.
RS-485+ RS-485 Data line
RS-485- RS-485 Data line
Analog video output port. (for installation)
Description