Non-Combustible Facing Material; Minimum Mantel Clearances - Napoleon GD36NTR Installation And Instruction Manual

40
6.6

NON-COMBUSTIBLE FACING MATERIAL

FINISH
EN
MATERIAL
TOP OF
APPLIANCE
WARNING: Non-combustible facing material may protrude from the top, and/or sides of this appliance,
as illustrated [up to a maximum of 6" (152.4mm)]. Greater than 6" (152.4mm) protrusions are considered a
6.5

MINIMUM MANTEL CLEARANCES

RISK OF FIRE, MAINTAIN ALL SPECIFIED AIR SPACE CLEARANCES TO COMBUSTIBLES. FAILURE
TO COMPLY WITH THESE INSTRUCTIONS MAY CAUSE A FIRE OR CAUSE THE APPLIANCE TO
OVERHEAT. ENSURE ALL CLEARANCES (I.E. BACK, SIDE, TOP, VENT, MANTEL, FRONT, ETC.) ARE
WHEN USING PAINT OR LACQUER TO FINISH THE MANTEL, THE PAINT OR LACQUER MUST BE
Combustible Mantel clearance can vary according to the Mantel depth. Use the graph
to help evaluate the clearance needed. These same requirements apply to any
combustibles protruding on either side of the appliance.
W415-0773 / F / 08.26.13
NON-COMBUSTIBLE
FACING MATERIAL
4" (102mm)
2" (51mm)
0" (0mm)
6" (152mm)
4" (102mm)
2" (51mm)
mantel and must meet the combustible mantel requirements.
HEAT RESISTANT TO PREVENT DISCOLOURATION.
TOP OF APPLIANCE
FRONT OF
APPLIANCE
2" (51mm)
4" (102mm)
6" (152mm)
0" (0mm)
2" (51mm)
4" (102mm)
WARNING
!
CLEARLY MAINTAINED.
12" (304.8mm)
10" (254.0mm)
8" (203.2mm)
6" (152.4mm)
4" (101.6mm)
2" (50.8mm)
FINISH MATERIAL
NON-COMBUSTIBLE
FACING MATERIAL
71.4B
73.1
2 4 6 8 10 12
MANTEL DEPTH (INCHES)