Table of Contents
Advertisement
EAN-8 with add-on
A code ID mark precedes add-on code data under the conditions "Code ID mark: Type 4" and "Code ID mark output mode:
Separating." (For details about the code ID mark, refer to (5) Code ID mark on 12.4.)
The conversion to the GTIN format is selectable. For the GTIN format conversion, refer to Section 12.5.
When the conversion to the GTIN format is disabled, the following formats apply.
With 2-digit add-on:
P
P
P
X
X
X
X
C/D X
1
2
3
1
2
3
4
With 5-digit add-on:
P
P
P
X
X
X
X
C/D X
1
2
3
1
2
3
4
P
: Prefix characters
n
X
: Add-on code data
5-9
Code 39
Code data read will be transmitted as is.
You can select whether or not to transmit start and stop codes ("*").
Interleaved 2of5
The scanner transmits code data read, starting from the character following the start code to the one preceding the stop code.
No start/stop codes will be transmitted.
Codabar (NW-7)
The scanner transmits code data read including the start/stop codes. You can select whether or not to transmit start/stop codes.
Code 128 (GS1-128(EAN-128))
The scanner transmits code data read, starting from the character following the start code to the one preceding the check digit.
Start/stop codes, FNC codes, or check digit will not be transmitted. Note that FNC1 placed in character positions other than
the 1st and 2nd ones from the start code will be converted to GS (1Dh) ,and can be selectable from either transferred or user
selection.
The conversion to the GTIN format is also selectable. For the GTIN format conversion, refer to Section 12.5.
Code 93
The scanner transmits code data read, excluding start and stop codes and a check digit.
GS1 DataBar (RSS)
Code data read will be transmitted as is.
FNC1 of GS1 DataBar Expanded (RSS Expanded) will be converted to GS(1Dh) and can be selectable from either transferred
or user selection. The conversion to the GTIN format is also selectable. For the GTIN format conversion, refer to Section 9.5.
GS1 DataBar (RSS) Composite symbols
Code data read will be transmitted as is.
Under the conditions "Code ID mark: Type 1" and "Code ID mark output mode: Separating," a separator (GS: 1Dh) and 2D
code ID mark are inserted between the linear component and 2D Composite component. (For details about the code ID mark,
refer to (5) Code ID mark on section 12.4.)
Under the conditions "Code ID mark: Type 4" and "Linear component length (RSS/EAN-128): Variable," a separator (GS:
1Dh) is inserted between the linear component and 2D Composite component.
UPC/EAN Composite symbols
Code data read will be transmitted as is.
You can select whether or not to transmit a check digit of the linear component (UPC/EAN).
Under the conditions "Code ID mark: Type 1" and "Code ID mark output mode: Separating," a separator (GS: 1Dh) and 2D
code ID mark are inserted between the linear component and 2D Composite component.
Under the conditions "Code ID mark: Type 2," the 2D code ID mark is inserted between the linear component and 2D
Composite component. (For details about the code ID mark, refer to (5) Code ID mark on section 12.4 .)
X
5
6
X
X
X
X
5
6
7
8
9
64
Advertisement
Table of Contents
