Table of Contents
Advertisement
this definition, the "trailer" can be a trailer, a
vehicle towed on a dolly, or a vehicle towed by
means of a tow bar. GCWR is typically specified
based on durability and performance of the tow
vehicle drive train: engine and cooling systems,
transmission, drive line, drive axle, and others.
The tow vehicle brakes may be rated for
operation at GVWR, not GCWR.
NOTE: State or provincial laws/regulations may
require the "trailer" to be equipped with
brakes that are activated when the
motorhome brakes are applied. The user
is responsible to know and understand
the laws of the state or province being
traveled. The Department of
Transportation in a given state or
province should be able to provide
specific information.
Hitch Ratings
SAE Standard J684 defines:
•
Class 1 trailers as "GVWR not to exceed
2,000 lbs".
•
Class 2 trailers as "GVWR over 2,000 lbs. and
not to exceed 3,500 lbs. GVWR".
•
Class 3 trailers as "GVWR over 3,500 lbs. and
not to exceed 5,000 lbs. GVWR".
•
Class 4 trailers as "GVWR over 5,000 lbs. and
not to exceed 10,000 lbs. GVWR".
Hitches are to be permanently marked with
"Maximum trailer GVWR to be drawn" and
"Maximum vertical tongue weight to be
imposed." The SAE standard does not specify a
vertical load rating.
Traditionally, hitches are labeled 3,500/350 as
Class 2, 5,000/500 as Class 3, and 10,000/1,000
as Class 4. The vertical tongue load value of 10
percent of drawn rating comes from the
collective experience that 10 percent is the
minimum value that provides stable towing of a
trailer.
Ford's towing guide suggests 10 to 15 percent
for trailers over 2,000 lbs. Within GCWR, a
Class 3 hitch allows "dingy" towing a large car or
mid-size SUV; a Class 4 hitch allows "dingy"
towing a large SUV or pickup. (Hitch ratings are
independent of towing vehicle ratings.)
NOTE: Some Winnebago Industries
equipped with a Class 3 hitch may have a
label limiting vertical tongue load to 350
lbs. All Winnebago Industries models
equipped with a Class IV hitch have a
label limiting vertical tongue load to 500
lbs. On a 228" wheelbase, a 500-lb. load
on a hitch 11' from the rear axle will
apply about 800 lbs. at the axle.
The user must verify that the hitch equipment
being used is adequate for the application.
AWNING – MANUAL
–If Equipped
Further Information
For complete operating instructions, refer to
the manufacturer's information provided in your
InfoCase.
AWNING – POWER
–If Equipped
The Power Awning switch is located near the
entrance door.
Power Awning Switch
(Located near entrance door)
-Typical View
SECTION 12 –
MISCELLANEOUS
®
models
12-5
Hide quick links:
Advertisement
Table of Contents
