Lexmark T650n Service Manual page 107

Error
code or Error contents
message
28x.61 DMID command is not
received for 500ms
x = bin
after main motor runs
number
Applies to:
StapleSmart finisher
28x.62 When finishing job
isn't completed yet,
x = bin
the first DMID
number
command of the next
job is received.
Applies to:
StapleSmart finisher
28x.63 Bin clamp motor
control timer error.
x = bin
number Applies to:
StapleSmart finisher
28x.64 Bin clamp motor
control timer error
x = bin
during tray holder
number
initial.
Applies to:
StapleSmart finisher
28x.65 Bin clamp home
position jam
x = bin
number Applies to:
StapleSmart finisher
28x.66 Bin clamp home
position jam
x = bin
number Applies to:
StapleSmart finisher
28x.67 Invalid bin clamp
manager state.
x = bin
number Applies to:
StapleSmart finisher
Description/Action
A software failure has occurred
with the output option.
A software failure has occurred
with the output option.
A software failure has occurred
with the output option.
A software failure has occurred
with the output option.
The bin clamp home position is
not detected by the sensor (bin
clamp HP)
The sensor (bin clamp HP)
does not detect that the bin
clamp has moved from home
position.
A software failure has occurred
with the output option.
Possible repair actions
1. Turn the machine off/on.
2. Replace the output option if
problem remains.
1. Turn the machine off/on.
2. Replace the output option if
problem remains.
1. Turn the machine off/on.
2. Replace the output option if
problem remains.
1. Turn the machine off/on.
2. Replace the output option if
problem remains.
1. Turn the machine off/on.
2. Replace the output option if
problem remains.
1. Turn the machine off/on.
2. Replace the output option if
problem remains.
1. Turn the machine off/on.
2. Replace the output option if
problem remains.
Diagnostic information
4062
2-75