Secure the water line.
Clip A
Clip A
Water line
Water line
Removing any residual matter inside the water supply line after installing filter.
1. Turn ON the main water supply &
turn OFF the valve to the water
supply line.
2. Run water through the dispenser
until the water runs clear
(approximate 3 liter). This will
clean the water supply system and
remove air from the lines.
3. Additional flushing may be
required in some households.
4. Open the refrigerator door and
make sure there are no water leaks
coming from the water filter.
NOTE
A newly installed water filter cartridge
may cause water to briefly spurt from the
water dispenser. This is due to air getting
into the line. It should pose no problem to
operation.
DA68-03176A (EN)-00.indd 37
DA68-03176A (EN)-00.indd 37
•
Using clip (A), fix the water line to the
wall (the back of refrigerator).
•
When the water line is secure, make
sure whether the water line is not
excessively bent, pinched or squashed.
English 37
2015. 1. 14.
2015. 1. 14.
2:50
2:50