Dimplex DFI400R Owner's Manual page 9

Assembly
Figure 5
Emitter
Transducer
Wire Slot
should be refilled after the
Reservoir has filled to ensure the
maximum operating time.
8. Install the media on top, media
tray and media (if applicable),
so that the opening is not
blocked (Figure 6).
CAUTION: Do not arrange the
media while the unit is running,
since the media and/or tray may be
hot.
9. Make sure the On/Off switch
is switched to Off (refer to
Operating Instruction section).
10. Plug the unit into a 15 Amp/
120 volt outlet.
Top
Cover
Water Tank
Figure 6
!
NOTE: Rock media shown, install
other medias in the same way.
Retaining
Tab
Fan
Housing
9