Cargo Tie-Downs; Convenience Net; Roof Rack System - GMC 2011 Yukon XL Denali Owner's Manual

To put the cover in the vehicle:
1. Make sure the cover slot in the
holder faces rearward with the
round surface facing down.
2. Then, hold the cover at an angle
and place the cover end cap into
the slot in the passenger side
trim panel.
3. Move the other end of the cover
forward and hold it next to the
driver side trim panel slot.
4. Press the end caps in, to allow
the cover to fit into the trim slot.
5. Pull lightly on the cover holder to
make sure it is secure.
On extended wheelbase models
there are two cover positions.
The slots furthest forward allow
the cover to be used if the
third seat is removed or folded
down. The cover can be
installed and removed from
either side.

Cargo Tie-Downs

If the vehicle has cargo tie downs
located in the rear cargo area, these
can be used to strap cargo down
and keep it from moving inside the
vehicle.

Convenience Net

Use the convenience net, located in
the rear, to store small loads as far
forward as possible. The net should
not be used to store heavy loads.
Storage

Roof Rack System

WARNING
If something is carried on top of
the vehicle that is longer or wider
than the roof rack like paneling,
plywood, or a mattress
wind can catch it while the vehicle
is being driven. The item being
carried could be violently torn off,
and this could cause a collision
and damage the vehicle. Never
carry something longer or wider
than the roof rack on top of the
vehicle unless using a GM
certified accessory carrier.
For vehicles with a roof rack, the
rack can be used to load items.
For roof racks that do not have
crossrails included, GM Certified
crossrails can be purchased as an
accessory. See your dealer for
additional information.
4-3
the