Ztbss1 Tubular Handle Kit - GE ZIFI240 Installation Instructions Manual

ZTBSS1 Monogram Tubular Handle Kit
BEFORE YOU BEGIN:
•
Read these instructions completely and carefully.
IMPORTANT:
•
Save these instructions for local inspector's use.
IMPORTANT:
•
Observe all governing codes and ordinances.
• Note to Installer – Be sure to leave these instructions
with the Consumer.
• Note to Consumer – Keep these instructions with your
Owner's Manual for future reference. This kit provides a
stainless steel tubular handle to coordinate with other
Monogram appliances.
• The tubular handle must be installed onto the 3/4"
thick portion of the custom wood panel before
the panel is secured to the door.
INSTALL THE TUBULAR HANDLE
• Use the handle as a template to locate and mark the
exact position of the screw holes. Be careful to avoid
interference with custom panel mounting screws.
• Draw a pencil line, top to bottom and 7/8" from the
outside edge.
• Hold the tubular handle against the appearance side,
centered on the marked line.
• Mark the screw hole locations at the center of the
handle attachment posts.
• Center punch the marked hole locations. Drill 1/4" pilot
holes from the appearance side through the entire panel
thickness.
• Use a 1/2" spade bit to drill 1/4" to 5/16" deep into
the back side of the panel. Insert washer (spacer) into
the hole.
• Install screw through the handle standoff and into
the pilot hole.
• Fasten nut onto the screw until the standoff is tight
against the panel. The screw hole on the standoff
should be pointing down toward the floor.
• Place handle attachment posts inside the standoffs.
• Use the Allen wrench to install the set screws. Tighten
handle to standoffs.
TOOLS AND MATERIALS REQUIRED:
• Gloves to protect against sharp edges
• #2 Phillips screwdriver
• Drill and 1/4" bit and 1/2" spade bit
• Safety glasses
• Center punch
• Pencil
THIS KIT INCLUDES
• Tubular handle
• 2 Mounting screws
• 2 Handle standoffs
• 2 Set screws for standoffs
• 2 Nuts
• 2 Washers
• Allen Wrench
7/8"
24-7/32"
Washer
Nut
9
30"
Custom
Framed
Panel
Tubular
Handle
Handle
Standoff
Handle
Attachment
Post
Set
Screw
Screw