GE ZIFI240 Installation Instructions Manual
Fresh-food refrigerator
bar refrigerator with icemaker
Hide thumbs
Also See for ZIFI240:
- Owner's manual (21 pages) ,
- User manual (21 pages) ,
- Owner's manual (20 pages)
Related Manuals for GE ZIFI240
Summary of Contents for GE ZIFI240
- Page 1 Design Guide with Installation Instructions Fresh-Food Refrigerator ZIFI240 ZIFS240 Bar Refrigerator with Icemaker ZIBI240 ZIBS240 monogram.com...
-
Page 2: Safety Information
For Monogram Parts and Accessories, call skills. Proper installation is the responsibility of the 1.800.626.2002. installer. Product failure due to improper installation is not covered under the GE Appliance Warranty. monogram.com GROUNDING THE FRESH-FOOD REFRIGERATOR OR BAR REFRIGERATOR WITH ICEMAKER IMPORTANT –... -
Page 3: Table Of Contents
Shaded Area max. 120 p.s.i. • The water line can enter the opening through 1/2" 10-1/2" the floor or back wall. Route 1/4″ O.D. copper tubing or GE 1-1/2" Floor SmartConnect ™ kit between the cold water line and water min. -
Page 4: Design Guide (For Zifs240 And Zibs240)
• All models may be used freestanding. models ZIFI240 and ZIFS240 only. Models ZIBI240 and • If installing a stainless steel model between frameless ZIBS240 are not available with left hand door swing. -
Page 5: Design Guide (For Zifi240 And Zibi240)
Design Guide For models ZIFI240 and ZIBI240 with Custom Door Panels and Handles THE INSTALLATION SPACE PRODUCT CLEARANCES The Fresh-Food Refrigerator or Bar Refrigerator with Icemaker is factory set for a 110° door swing. Locate When installed in a corner: Outlet •... -
Page 6: Installation Instructions
STEP 1 REMOVE PACKAGING STEP 2 INSTALL CUSTOM 3/4″ DOOR AND INSTALLATION PARTS PANEL AND HANDLE (CONT.) (ZIFI240 and ZIBI240 models only) • Remove corner blocks and foam drawer stops. • Remove all packing material, tape and protective Assemble overlay panels Overlay Panel plastic coverings. -
Page 7: Step 3, Leveling
PANEL AND HANDLE (CONT.) • Use an adjustable wrench to turn the leveling legs and (ZIFI240 and ZIBI240 models only) raise or lower the product. Install custom door panel and handle (cont.): For built-in installation, adjust the leveling legs slightly below •... -
Page 8: Step 5 Connect Power
Installation Instructions STEP 5 CONNECT POWER STEP 7 SET TEMPERATURE CONTROLS • Connect power cord plug to a properly grounded receptacle. • The temperature controls are preset. Refer to • Check to make sure power is on by opening the door the Owner’s Manual for more information. -
Page 9: Ztbss1 Tubular Handle Kit
ZTBSS1 Monogram Tubular Handle Kit BEFORE YOU BEGIN: TOOLS AND MATERIALS REQUIRED: • Read these instructions completely and carefully. • Gloves to protect against sharp edges • #2 Phillips screwdriver IMPORTANT: • • Drill and 1/4″ bit and 1/2″ spade bit Save these instructions for local inspector’s use. - Page 10 Notes...
- Page 11 Notes...
- Page 12 1.800.444.1845. NOTE: Product improvement is a continuing endeavor at General Electric. Therefore, materials, appearance and specifications are subject to change without notice. GE Consumer & Industrial Pub. No. 31-51544-5 Appliances Part No. 197D5893P002 General Electric Company...