Table of Contents
Advertisement
38
User Guide
7. Locate the Clear CMOS/Recovery jumper on the system board, removing any
adapters that impede access to the jumper. See the system board label inside
your computer for the location of the jumper. See also "Identifying parts on
the system board" on page 16.
8. Remove the jumper from the system board.
9. Replace the cover. See "Replacing the cover and connecting the cables" on
page 29.
10. Reconnect the power cords for the computer and monitor to electrical outlets.
11. Insert the BIOS update (flash) diskette into drive A, and turn on the computer
and the monitor.
12. After the update session is completed, remove the diskette from the diskette
drive, and turn off the computer and monitor.
13. Unplug the power cords from electrical outlets.
14. Remove the cover. See "Removing the cover" on page 15.
15. Remove any adapters that impede access to the BIOS Configuration jumper.
16. Replace the Clear CMOS/Recovery jumper to its original position.
17. Replace any adapters that were removed.
18. Replace the cover and reconnect any cables that were disconnected.
19. Turn on the computer to restart the operating system.
20. Restore the config.sys file on the diskette back to:
shell = flash2.exe
Advertisement
Table of Contents
