Ford 2013 Explorer Owenrs Manual page 195

Hide thumbs Also See for 2013 Explorer:

Table of Contents

Universal Garage Door Opener

If the indicator light stays on, programming is complete. Press and

release the programmed button to activate the door.

If the indicator light flashes rapidly for two seconds than turns to a

constant light, follow the steps below.

To program additional buttons repeat steps one through four.

For questions or comments, please contact HomeLink at

www.homelink.com or 1-800-355-3515.

Erasing the Function Button Codes

2013 Explorer (exp)

Owners Guide gf, 1st Printing

Note: You may need a ladder to

reach the unit and you may need to

remove the cover or lamp lens.

1. Press the learn button on the

garage door opener motor.

Note: You will have 30 seconds to

complete the next step.

2. Return to your car.

3. Press and hold the function

button for 2 seconds, then release.

Repeat this step. Depending on the

brand of garage door opener you

may do repeat this sequence a third

Note: You can not erase individual

1. Press and hold the outer two

function buttons simultaneously for

approximately 20 seconds until the

indicator lights above the buttons

flash rapidly.

2. When the indicator lights flash,

release the buttons. The codes for

all buttons are erased.