Tour; Finish Route Guidance; Abort Route Guidance - Skoda Bolero Owner's Manual

›
 - Arrival time at destination
1)
›
 - Remaining travel time to the destination
›
Route type (economic, fastest, shortest)
›
Current vehicle position (coordinates)

Finish route guidance


Read and observe on page 56 first.
The route guidance can be finished in one of the following ways.
›
The final destination is reached.
›
Press in the Navigation menu the function key  → Stop route guidance.
›
If a route guidance is in progress, then a new tour is to be entered and finish-
ing the guidance by pressing the function key Finish.
›
The ignition is off for longer than 120 min.

Abort route guidance


Read and observe on page 56 first.
If the ignition is switched off and on again, then the route guidance is contin-
ued depending on the stop time in one of the following ways.
›
Within 15 min - route guidance is continued taking into account the calcula-
ted route.
›
Between 15 min and 120 min - the screen displays the message Continue
route guidance?, after you confirm the message, the route guidance contin-
ues using the calculated route.
›
After 120 min - the route guidance is cancelled.

Tour


Introduction
This chapter contains information on the following subjects:
Tour setting
Edit tour
Tour memory management
1) If the time of arrival to the final destination or remaining travelling time greater than 24 hours,  is dis-
played inside the symbol.
1)
59
60
60
Tour setting
Tour creation (occurs no guidance)
›
Press in the Navigation menu the function key  → New tour.
Insert a destination in one of the following ways.
›
Press the function key » Fig. 44
A
or
›
Press the function key and select a destination from the list of registered
B
destinations » page 50.
The created tour can be stored by pressing the function key
guidance can be started by pressing the function key
Tour creation (starts a route guidance)
›
Press in the Navigation menu the function key  → New dest./stopover.
›
Enter destination.
›
Press the function key Start→ Stopover.
The created tour can be stored by pressing the function key
guidance can be started by pressing the function key
Fig. 44
Entering a new tour
and enter a new destination.
or the route
C
.
D
or the route
C
.
D
Navigation (Amundsen)
59