Code Set; Status Up; Status Down; Status Set - Vertex Standard VX-4200 Series Operating Manual

C U /D
ODE P OWN
Press the assigned programmable key to select a 5-Tone encode code from pre-
defined encode list.
C S
ODE ET
Press the assigned programmable key to change the 5-Tone encodeing digit. To change
the tones, select the desired digit using the [ P1 ] / [ P2 ] keys, then change the number
using the [ ] / [ ] keys.
S U /D
TATUS P OWN
Press the assigned programmable key to select a 5-Tone status code from the pre-
defined status list.
S S
TATUS ET
Press the assigned programmable key to change the 5-Tone status code. To change
the status code, select the desired digit of the status code using the [ P1 ] / [ P2 ] keys,
then change the number using the [ ] / [ ] keys.
S C
TATUS HECK
Press the assigned programmable key to check the 5-Tone receive status code. When
you press this key, the LCD display will indicate the "message" corresponding to the
receive status condition per the pre-defined status list.
S D
PEED IAL
Your Dealer may have pre-programmed Auto-Dial telephone number memories into
your radio.
To dial a number, press the assigned programmable key, then press the microphone's
numbered key corresponding to the Auto-Dial memory number list provided by your
Dealer. The DTMF tones sent during the dialing sequence will be heard in the speaker.
H C
OME HANNEL
Press the assigned programmable key to recall the pre-defined Home group/chan-
nel. When you recall the Home group/channel, the " - - - - - H H H H H - - - - - " icon will appear on the LCD.
S T
ELECTABLE ONE
Press the assigned programmable key to select a sub-audible tone (CTCSS/DCS)
from the pre-defined tone table. You can operate the indicated sub-audible tone in
Selectable Tone mode.
12
A
DVANCED
( HOME )
O
PERATION
VX-4200 S
ERIES
O M
PERATING ANUAL