Table of Contents
Advertisement
'krn and Lane Change Signals
The turn signal has two upward (for right) and two
downward (for left) positions. These positions allow you
to signal a turn or a lane change.
To signal a turn, move the lever all the way up or down.
When the turn is finished, the lever will return automatically.
An arrow on the instrument
panel will flash in the
direction of the turn
or lane change.
To
signal a
lane change. just raise or lower the lever
until the ;lrrocv
starts to
tlash. Hold
it
there until you
complete your
1mc change.
The lever will return by
itself when you
rclt.ast: i t .
As
you
signal
; 1
turn or
LI
lane change, if the arrows don't
flash but just
stay
011.
;I
signal bulb may be burned out
and other
drivers w o n ' t
see
your turn signal.
If a bulb is burned out, replace it to help avoid an
accident. If the arrows don't go on at all when you
signal a turn, check the fuse (see
"Fuses
and Circuit
Breakers'' in the Index) and for burned-out bulbs.
If you have a trailer towing option with added wiring for
the trailer lamps, a different turn signal flasher is used.
With this flasher installed, the signal indicator will flash
even if a turn signal bulb is burned out. Check the front
and rear turn signal lamps regularly to make sure they
are working.
Headlamp Highkow Beam Changer
To change the headlamps from low-beam to high or
high to low, pull the multifunction lever all the way
toward you. Then release
it.
1
When the high beams are
on,. this indicator light on
the instrument panel will
also be on.
2-39
Advertisement
Table of Contents
