LG LRG30355ST User Manual page 44

T RO U B L E S H O OT I N G
BEFORE CALLING FOR SERVICE
Problem
Oven door will not open
after a clean cycle
Oven not clean after a
clean cycle
"LOCK DOOR" flashes
in the display
LOCKED DOOR light
is on when you want
to cook
"F—and a number or
letter" flash in the display
Oven shelves are
difficult to slide
"Probe" appears
in the display
(convection models)
Display goes blank
Display flashes
Unable to get the
display to show "SF"
Power outage,
clock flashes
44
Possible Causes
• Oven too hot.
• Oven controls not properly set.
• Oven was heavily soiled.
• The self-clean cycle has been
selected but the door is not
closed.
• The oven door is locked
because the temperature
inside the oven has not
dropped below the
locking temperature.
• You have a function error code.
• If the function code repeats.
• The nickel shelves (if so equipped)
were cleaned in a self-clean cycle.
• This is reminding you to enter a
probe temperature after plugging
in the probe.
• A fuse in your home may be blown
or the circuit breaker tripped.
• The clock is in the
black-out mode.
• Power failure.
• Oven control pads were
not pressed properly.
• Power outage or surge.
Solutions
• Allow the oven to cool below locking temperature.
• See the Using the Self-Cleaning Oven section.
• Clean up heavy spillovers before starting the clean
cycle. Heavily soiled ovens may need to self-clean
again or for a longer period of time.
• Close the oven door.
• Touch the CLEAR/OFF pad. Allow the oven to cool.
• Touch the CLEAR/OFF pad. Allow the oven to cool for
one hour. Put the oven back into operation.
• Disconnect all power to the range for 5 minutes
and then reconnect power. If the function error
code repeats, call for service.
• Apply a small amount of vegetable oil to a paper
towel and wipe the edges of the oven shelves with
the paper towel. Do not spray with Pam
lubricant sprays.
• Enter a probe temperature.
• Replace the fuse or reset the circuit breaker.
• See the Special Features of Your Oven Control
section.
• Reset the clock.
• The BAKE and BROIL HI/LO pads must be touched
at the same time and held for 3 seconds.
• Reset the clock. If the oven was in use, you must
reset it by touching the CLEAR/OFF pad, setting the
clock and resetting any cooking function.
® or other