Install The Range; Electrical Connection Requirements; Anti-Tip Device Installation; Final Installation - LG LRE3091S Installation Manual

Part 3

INSTALL THE RANGE

3
ELECTRICAL CONNECTION
REQUIREMENTS
The range must be installed in accordance with Local
and Canadian Electrical Codes (latest edition). See
rating plate for total connected Amp rating. This
model was shipped direct from the factory with
Service cord attached. There are no range
connections necessary.
Note: Cord replacement
Only a range cord rated at 40 amps with 120/240
minimum volt range is required. If a 50 amp range
cord is used, it should be marked for use with 1
diameter connection openings.
4

ANTI-TIP DEVICE INSTALLATION

WARNING
• DO NOT step or sit on the
door. Install the Anti-Tip
Bracket packed with range.
- The range could be tipped and
injury might result from spilled hot
liquid, food, or the range itself.
- If the range is pulled away from the
wall for cleaning, service, or any
other reason, ensure that the Anti-
Tip Device is properly reengaged
when the range is pushed back
against the wall.
1. Locate the bracket using the template
An Anti-tip bracket is packaged with template. The
instructions include necessary information to
complete the installation.
Read and follow range installation instruction sheet
(template).
2. Level the range
Level the range by adjusting the leveling legs with a
wrench.
Use a spirit level to check your adjustments. Place the
level diagonally on the oven rack, and check each
3
⁄ "
8
direction for level.
First check direction
After check direction
If the spirit level doesn't show
level on the rack, adjust the
leveling legs with a wrench.
5

FINAL INSTALLATION

• Move range close enough to the opening to plug
into the receptacle.
• Slide range into position insuring that the left back
leg slides under the anti-tip bracket. Range will sit 0"
away from the back wall when properly installed.
• Carefully tip range forward to insure that the anti-tip
bracket engages the range back brace and prevents
tip-over.
• Turn on electrical power. Check range for proper
operation as described in owner's manual.
If the counter does not bridge the opening at the rear
wall the rear filler kit, that is provided with the slide in
range, will be needed.
NOTE : If the countertop depth is greater than 25"
there will be a gap between the filler kit and the back
wall.
If the countertop depth is less than 24", the control
panel will not sit flush with the countertop.
(See figure 1 on page 5)
6
.
1
.
2
Optional rear filler