Table of Contents
Advertisement
[2] INSTALLATION DRAWINGS (LDE Series only)
PREPARE TO INSTALL THE RANGE
NOTE
SAVE FOR THE USE OF THE LOCAL
ELECTRICAL INSPECTOR.
CLEARANCES AND
DIMENSIONS
(Figure 1)
To install range refer to the following Figure 1.
For installation in CANADA, a Free-standing range
is not to be installed closer than 15/32 (12mm) from
any adjacent surface.
f
(
4 WARNING
)
* You should use two or more people to move
and install range. (Excessive Weight Hazard)
- Failure to do so can result in back or other injury.
¢ You never pull or push any handles of upper
& lower door to move and install range.
- Failure to do so can result in serious damage to
the door of the range.
J
*
(
( CAUTION
)
* You should make sure that the wail
covering, countertop and cabinets
around the range can withstand the heat
(up to 194°F) generated by the range.
- Discoloration, delamination or melting may occur.
- This range has been designed to comply with
the maximum allowable wood cabinet
L temperatures of 194°F.
24"
nel
(60.9cm)
|
3" (7.6m)
3" (7.6cm)
1
25
Norma
63. Bom Normal
top depth
Acceptable
electrical
outlet area.
SS
Counter
aan
" -4cm) top height
ats
Cabinet
a
opening
3
(
> )
4& CAUTION
* Cabinet storage space located above
the surface units should be avoided.
* You should install a range hood that
projects horizontally a minimum of 5
inches beyond the bottom of the cabinets.
If cabinet Storage is to be provided.
- The risk of burns or fire by reaching over the
\_ heated surface elements can be reduced.
/
OO
30
——_
(76.2cm)
*30" (76,2cm)
Minimum
5"(38cm)}
ay
—
Cabinet
9
rane
(23cm)
A
=
= 30"(76.2 cm)
30"°(76.2 cm) For U.S.A
~ 31°(78.7 cm) For CANADA
FIGURE 1
MINIMUM DIMENSIONS (Figure 2)
FIGURE 2
* 30" (76.2 cm) minimum
clearance between the top of the cooking surface and the bottom of an
unprotected wood or metal cabinet; or 24" (60.9 cm) minimum when
bottom of wood or metal cabinet is
protected by not less than 1/4"(6.4 cm) flame retardant millboard covered with not less than no. 28 MSG
sheet steel, 0.015"(0.381
mm) stainless steel, 0.024" (0.610 mm) aluminum or 0.020"(0.508 mm) copper.
** 15°(38.1 cm) minimum
between countertop and adjacent cabinet bottom.
5
Advertisement
Table of Contents
