Refitting The Driven Pulley Shaft Bearing; Baffle Roller; Plastic Roller - PIAGGIO X7 250ie Service Station Manual

Engine

Refitting the driven pulley shaft bearing

- Slightly heat the crankcase from the inside so as
not to damage the painted surface.
- Insert the bearing in its seat.
- Refit the seeger ring.
CAUTION
USE AN APPROPRIATE REST SURFACE TO
AVOID DAMAGING THE COVER PAINT.
N.B.
ALWAYS REPLACE THE BEARING WITH A
NEW ONE UPON REFITTING.
Specific tooling
020376Y Adaptor handle
020357Y 32 x 35 mm adaptor
020412Y 15 mm guide

Baffle roller

Plastic roller

- Check that the roller does not show signs of wear
and that it turns freely.
- Remove the special clamping screws as indica-
ted in the photograph
- Check the outer diameter of the roller does not
have defects that could jeopardise belt functioning
- For refitting, place the roller with the belt contain-
ment edge on the engine crankcase side
- Tighten the wrench to the prescribed torque.
Locking torques (N*m)
Anti-flapping roller 12 - 16
ENG - 4
X7 250ie