Chassis Maintenance; Wheel And Tyre Maintenance - Arrma Fury Manual

Chassis Maintenance

Tools Required
Cloth
AFTER RUNNING:
Ensure that drivetrain, suspension and
steering are clean, free and lubricated
Check that all the screws are tight
Check tyre/wheel condition
DO NOT RUN THE CAR IF ANY
PARTS ARE DAMAGED
Please contact your local distributor
to order replacement parts.
N.B. Raider chassis shown as an example - information applies to all variants.

Wheel and Tyre Maintenance

Tools Required
7mm Nut Driver
or
Cross Wrench
Tyre Glue
3
If the tyre needs re-glueing, gently pull tyre away
from the wheel rim, apply a small amount of tyre
glue, re-seat the tyre and hold until glue has set.
DESIGNED FAST. DESIGNED TOUGH.
Automotive
Brake
Cleaner or
Brush
Nitro Car
Cleaner
N.B. Fury shown as an example - information applies to all variants.
1
Ensure model is switched off and drive
battery is removed; then remove wheel with
7mm nut driver or crosswrench.
Online videos when
you see this icon >>
4
Refit the wheel with a 7mm nut driver or cross wrench 'finger-tight',
then tighten a further 1/4 turn. Do NOT over tighten the wheel nut or
damage to the wheel bearings may occur.
12
ARRMA-RC.COM/
SUPPORT/
2
Visually inspect the tyre sidewalls and tread
for damage or heavy wear. Replace wheel
and tyre if either is found to be worn. Check
that tyre bead is securely glued to the rim.
© 2013 ARRMA Durango Ltd. A subsidiary of Hobbico, Inc.
ARRMA-RC.COM/
SUPPORT/