Maintenance; Recommended Tools; Trouble Shooting Matrix - Arrma Fury Manual

Maintenance

Recommended Tools

Supplied
Allen Keys
1.3 (0.050"), 1.5, 2, 2.5mm
Cross wrench
Long Nose Pliers
Basic Trouble Shooting

Trouble Shooting Matrix

Problem
VEHICLE DOES NOT MOVE
V E H I C L E D O E S N O T
REVERSE
VEHICLE DRIVES WITHOUT
INPUT
SHORT RUNTIME
SLUGGISH PERFORMANCE Battery damaged or not fully charged
DESIGNED FAST. DESIGNED TOUGH.
Not Supplied
Hex Drivers
1.3mm (0.050")
1.5mm
2mm
2.5mm
Grease
Cloth
- need help? Visit the support area and forums at ARRMA-RC.COM
Possible Cause
Batteries are incorrectly installed in
transmitter
Weak, damaged or no drive battery in
model
Frayed or broken motor or electronic
speed control (ESC) wires
Electronic speed control (ESC) has shut
down due to overheating
Electric motor is damaged
El e c t r o n i c s p e e d c o n t r o l ( E S C ) i s
damaged
Possible damage to transmission/drive-
line
Electronic speed control (ESC) low
voltage cutoff has activated.
Electronic speed control (ESC) reverse
mode switched off
El e c t r o n i c s p e e d c o n t r o l ( E S C ) i s
damaged
Transmitter throttle trim incorrectly set
Neutral throttle position of Electronic
Speed Control (ESC) incorrect.
Battery damaged or not fully charged
Electric motor dirty or damaged
Incorrect electronic speed control (ESC)
battery mode.
Transmitter throttle trim incorrectly set
Nut Drivers
5.5mm
7mm
Thread-lock
Oil
Brush
Spray
Solution
Check transmitter batteries and refit.
Install fresh, charged battery
Check condition, reconnect and insulate. Visit
the GO FOR IT! forum for advice
Stop driving and allow electronic speed control
(ESC) or motor to cool down
Replace with new unit - visit ARRMA-RC.com
for advice and upgrades!
Replace with new unit - visit ARRMA-RC.com
for advice and upgrades!
Check components and replace - visit ARRMA-
RC.com for advice
Remove drive battery, leave to cool down if
necessary, and re-charge
Adjust reverse on electronic speed control
(ESC)
Replace with new unit - visit ARRMA-RC.com
for advice and upgrades!
Throttle trim needs to be set to zero/neutral.
Set throttle trim to zero and switch electronic
speed control (ESC) off and then on again, a
chime to indicate the new neutral position has
been set
Check condition, replace or recharge
Clean, check condition and/or replace - visit
ARRMA-RC.com for more information
Adjust the battery mode of the electronic
speed control (ESC)
Check condition, replace or recharge
Throttle trim needs to be set to zero/neutral.
10
Turnbuckle Wrench
4mm
HAZARDOUS/FLAMMABLE:
Adult supervision required, use
only in a well ventilated area and
away from sources of ignition.
Automotive
Brake
Tyre Glue
Cleaner or
Nitro Car
Cleaner
© 2013 ARRMA Durango Ltd. A subsidiary of Hobbico, Inc.