Gobo Replacement - Chauvet Rogue RH1 Hybrid User Manual

Setup
Gobo
Replacement
Procedure 1. Turn the product off and disconnect it from the power outlet.

Gobo Replacement

Diagrams
Gobo Wheel 2
-8-
The gobos in the Rogue™ RH1 Hybrid gobo wheel 2 are removable from their gobo holders.
This operation is quite simple, although it requires the technician to be careful and to follow the
recommended procedure.
· Make sure to disconnect the product's power cord before replacing a gobo
· Always replace a gobo with a gobo of the same dimensions.
When inserting a glass gobo, always make sure that the shiny side of the gobo
·
(glass base) faces the lamp. This provides a layer of protection against the high
temperature from the lamp.
2. Open the head cover by loosening the 4 Phillips-head ¼-turn screws on the sides of the top
cover.
3. Separate the gobo holder away from the gobo wheel by pushing it toward the front of the
moving head (direction 1 in the diagram). Be careful not to push the gobo out of the gobo
holder.
4. Extract the gobo holder by pulling it outward (direction 2 in the diagram).
5. On a flat surface, remove the expansion ring that holds the gobo in place and remove the
gobo from the gobo holder.
6. Insert a new gobo and hold it in place with the expansion ring.
7. Slide the tip of the gobo holder under the pressure plate near the center of the gobo wheel.
8. Push the gobo holder inwards. DO NOT force the gobo holder into the gobo wheel slot. If
correctly installed, the gobo holder should easily slide itself into the gobo wheel slot.
Gobo Holder
Gobo Holder
Glare Shield
Gobo
Retaining Spring
Rogue™ RH1 Hybrid User Manual Rev. 1