Table of Contents
Advertisement
3) On the receiving handset, to answer the call, press
ANSWER soft key. If you set the AutoTalk On, pick up the handset from the cradle. If
Anykey Answer is On, press any number key,
4) To finish the intercom call, press
Call Transfer Feature
1) During a call, press
2) Select a handset to transfer the call within 10 seconds.
(Refer to step 2 in the intercom section on page 42).
The call will automatically be placed on hold, and an
intercom tone sounds.
To cancel the transfer, press
3) On the receiving handset, to answer the page, press
the ANSWER soft key. If you set the AutoTalk On, pick up the handset from the cradle.
If Anykey Answer is On, press any number key,
is activated, but the caller is still on hold.
4) To transfer the call, press
press
or
REPLACING THE BASE
When you replace the base with a different base of the DCT series model (DSS2415,
DSS2455, or DSS2465 series), you need to clear the handset(s) and base ID. To do this,
perform the "System Reset" menu options ("De-register the Handset" and "Deregister the
Base Setting") (see page 19), then register all the handsets you have (see page 40).
, or
or the END soft key on either handset.
.
or
on the initiating handset.
, or
or the END soft key on the initiating handset, and
on the receiving handset.
,
, or the
.
H o l d , t o t r a n s f e r
H a n d s e t # 2
H a n d s e t # 3
BACK
BACK
OK
,
, or
. The intercom mode
[ 43 ]
Advertisement
Table of Contents
