RIDGID RD8000 Series Operator's Manual page 17

ASSEMBLy
LOOSE PARTS LIST
See Figure 4.
The following items are included with the generator:
Key
No. Description
1 Axle ......................................................................2
2 Wheel ...................................................................2
3 Flat Washer (5/8 in.) .............................................2
4 Hitch Pin ..............................................................2
5 Screw (1/4-20 x 2 in., Hex Hd.) ...........................4
6 Flat Washer (1/4 in.) .............................................6
7 Left and Right Legs with Rubber Feet .................2
8 Nut (1/4-20 Self-Locking Nut) .............................6
9 Control Panel Cord, 25 ft. ....................................1
10 Engine Lubricant..................................................1
11 Screw (1/4-20 x 1 in., Hex Hd.) ...........................2
12 Key.......................................................................1
Operator's Manual (not shown) ...........................1
TOOLS NEEDED
See Figure 5.
The following tools (not included or drawn to scale) are
needed for assembly:
 7/16 in. Socket Wrench
 7/16 in. and 8 mm Combination Wrench
NOTE: Do not put fuel or lubricant in the generator before
installing the legs and wheels.
INSTALLING LEGS
See Figure 6.
 Locate the following items:
Left and right legs with rubber feet
6 flat washers
6 lock nuts
4 screws (2 in.)
2 screws (1 in.)
 Raise the front end of the generator, where the engine is
located, high enough to gain access to the frame bottom;
securely position props underneath to support.
 Position a leg over the holes on each side of the frame
support. The tab on the leg should face the inside of the
generator frame.
 Insert each 2 in. screw through a flat washer and insert
the screws through the two holes in the frame and the
leg.
 Fasten the screws by installing a self-locking nut over
each screw on the inside of the frame. Tighten the nut
securely.
 Insert a 1 in. screw through a flat washer, the hole in the
frame crossbar, and then through the hole in the leg tab.
Install a self-locking nut and tighten to secure.
 Repeat with remaining leg.
INSTALLING THE WHEELS
See Figure 7.
Wheels are provided to assist in moving the generator to the
desired location and should be installed on the side opposite
the recoil starter.
Qty.
 Locate the following items:
2 axles
2 washers (5/8 in.)
2 hitch pins
2 wheels
 Raise the handle end of the generator high enough to
gain access to the frame bottom; securely position props
underneath to support.
 Insert an axle through the center of the wheel.
 Place a washer on the axle, then slide the axle through
the bracket on the frame.
 Slide the hitch pin through the hole in the axle and make
sure it is secure.
 Repeat the process on the other side to install second
wheel.
CONNECTING BATTERy
See Figure 8.
The battery cables must be connected before the electric
start feature of the generator can be operated.
 Connect the red wire to the positive (+) terminal first,
then connect the black wire to the negative (−) terminal
using the bolts, nuts, and washers provided. Make sure
all connections are tight.
NOTE: Be careful not to short across the terminals when
installing. Shorting the terminals together can cause
sparks, damage to the battery or generator, or even burns
or explosions.
 Cover the terminals with the rubber covers.
When removing the battery for replacement: remove the
nut and bolt first from the negative (black) post, then from
the positive (red) post, being careful not to short across the
terminals. Always abide by the safety warnings provided with
the battery. Remove the battery and dispose of according
to local and state regulations.
WARNING:
To reduce the risk of electrocution or explosion, do
not short circuit the battery terminals or charge in a
sealed container. Keep sparks and flame away.
WARNING:
Keep metal objects away from the battery terminals.
Metal objects can make a connection from one
terminal to another. Shorting the battery terminals
together may cause sparks, burns, or a fire.
11 — English