Problem Solving Guide - Miele DGC 6805 Operating And Installation Instructions

With the aid of the following guide, minor problems can be easily corrected
without contacting Miele. This will save you time and money because you won't
need to book a service technician.
Please note that a call-out fee will be applied for unnecessary service visits where
the problem could have been rectified as described in these operating
instructions.
,
Installation work and repairs to electrical appliances must only be carried
out by a suitably qualified and competent person in strict accordance with
current local and national safety regulations. Repairs and other work by
unqualified persons could be dangerous. The manufacturer cannot be held
liable for unauthorised work.
Problem
You cannot switch
the appliance on.
The Demo mode has
been switched on
and the appliance
does not heat up.
The fan can still be
heard after the
appliance has been
switched off.
Possible cause and remedy
The fuse is defective or has tripped.
^ Reset or replace the fuse (see data plate for minimum
fuse rating).
There may be a technical fault.
^ Disconnect the appliance from the mains connection
for approx. 1 minute:
– switch off at the wall socket, or switch off at the isolator,
or
– disconnect the mains fuse.
^ Reset the trip switch in the mains fuse box, and switch
the appliance back on. If it still will not switch on,
contact a qualified electrician or Miele.
^ You need to deactivate the Demo mode (see "Settings /
Showroom programme" ).
The appliance is fitted with a fan which removes steam
from the oven. The fan will continue to run for a while after
the appliance has been switched off.
The fan will switch itself off after a while.

Problem solving guide

145