Table of Contents
Advertisement
APPENDIX C: Troubleshooting
Blank screen
•
Maybe the device connected to the input jacks is not turned on.
•
Try another channel.
•
Press RESET, in case the picture controls are set too low.
No sound, picture okay
•
Maybe sound is muted. Try pressing volume up button to restore sound.
•
Maybe TV's speakers are turned off. Check the Audio Output and Speakers control panel in the Audio
menu.
•
If using an S-VHS component, remember to also connect the component's L and R AUDIO OUT jacks to the
TV's L and R INPUT 1 jacks.
Can't select certain channel
•
If using a VCR, check to make sure the TV/VCR switch on the VCR is in the correct position.
Noisy stereo reception
•
May be a weak station. Use SOUND button to change to mono mode instead of stereo.
No picture, no sound but power light is on
•
Maybe the cable/air function is set to the wrong position.
•
Maybe a vacant channel is tuned.
•
If watching VCR (connected only through antenna input), make sure TV is tuned to channel 3 or 4 – same as
CH3/4 switch on VCR. Also check to make sure TV/VCR switch on VCR is in correct position.
Sound okay, picture poor
•
Check antenna connections.
•
Try adjusting sharpness function to improve weak signals.
Black Box appears on the screen:
•
Captioning may be turned on. Check the Closed-Caption Display control panel in the Channel menu.
71
Advertisement
Table of Contents
