Programming The Remote; To Control A Vcr - RCA 1512786B User Manual

Programming the Remote

Programming the Remote
The universal remote can be programmed to control most
brands of remote controllable VCRs and cable boxes. The remote
is already programmed to control most RCA, GE and ProScan TVs
VCRs, DVD players, laserdisc players and satellite receivers. Other
manufacturer's brands need to be programmed.
Programming the Remote to Control
a VCR
To determine whether the universal remote needs to be
programmed, turn the VCR on, point the remote at the VCR,
and press the VCR1 button. Then press POWER or CH ^ (channel
up) or CH v (channel down) to see if the VCR responds to the
remote commands. If not, the remote needs to be programmed.
Follow these steps to program your universal remote to control
your VCR:
1. Turn on the VCR to be programmed.
2. Look up your VCR brand and code number(s) on the code list
on the next page.
3. Press and hold the VCR1 button on the remote.
4. Enter the two-digit code from the code list.
5. Release VCR1 then press POWER to see if the VCR responds
to the remote commands. If it doesn't, try pressing VCR1 and
POWER to see if the VCR responds.
6. Repeat these steps using the next code listed for your brand,
until the VCR responds to the remote commands.
¥
DVD VCR AUDIO
2
1 2
4 5
7 8
0
You'll use these buttons when you
program the remote to control any
devices.
This remote may not operate all
models of the brands that are shown.
Use the codes shown at right or on
the sheet packed in with your remote.
To program the DVD•VCR2 button to
control a second VCR, follow these
steps but use the DVD•VCR2 button
instead of the VCR1 button.
3
6
9
26