Table of Contents
Advertisement
1. Connect one end of the remote control cable to the SYNC In port on one projector, and connect the
other end to the SYNC Out port on the other projector.
Note: If you are connecting three or more projectors, connect the projectors in a chain as shown.
2. In the Extended menu, set the Sync of Projectors setting to Wired.
Note: If you are using the projector in the same room as another projector that does not support
cable connection or if you do not have the optional remote control cable, set the Wired Sync Mode
setting to Mode 2 in the projector's Extended menu.
Parent topic:
Installing Batteries in the Remote Control
The remote control uses the two AA batteries that came with the projector.
Caution: Use only the type of batteries specified in this manual. Do not install batteries of different types,
or mix new and old batteries.
Projector Connections
45
Advertisement
Table of Contents
