Andrew 960 .96 Meter Class I Assembly Instructions Manual page 9

ASSEMBLY AND INSTALLATION
for
Class II Antennas
Class II Side Feed Legs and Mount Braces Installation
Before attaching side feed legs, locate mount braces and identify left and right parts. Attach one end of each brace (flattened oval end with
slotted hole) to the az/el mount housing with carriage bolt, washer, lock washer and hex nut as shown below. Do not tighten . Swing
opposite end of mount brace in position to align flange holes with holes in side rim of reflector as shown.
NOTE:
Long formed end of side feed leg attaches to the reflector rim, short
formed
end to side of feed
support
junction block.
From the inside of reflector rim, insert M6 x 16 mm hex bolt through flat washer and aligned slot of mount brace, reflector rim side hole and
hole in feed support leg . Secure side feed legs and mount braces to reflector side rim with lock washer and hex nut. Do not tighten.
M6 Lock Washer
(2
Places)
M6 Flat Washer
(2
Places)
Left Mount Brace
M6 x
22
mm
Round Head
Square Neck
Bolt
(2 Places)
Side Feed Leg
M6 Hex Nut
Flat Washer
7
Right Mount Brace
IMPORTANT: DO NOT assemble
bottom feed support tube until instructed
to do so. Early assembly may cause
damage to reflecter.