Canon PIXMA MP970 series Quick Start Manual page 134

5
When the Network Setup of the Card Slot
dialog box appears, specify the drive letter,
then click Next.
W
Note
The Card Slot of the machine must be mounted to be
used as the memory card drive of the LAN-connected
computer.
To write files to a memory card, set the Read/write
attribute setting under Device settings to LAN
enabled. If the setting is set to USB enabled, you
cannot access the network drive of the Card Slot.
If "Communication with the Card Slot failed." is
displayed, click
Retry.
If it still fails, click Skip to
complete the setup. Then try the network setup of
the Card Slot using the Canon IJ Network Tool.
W
Note
• If "Cannot map any more drives, because all the
drive letters are assigned." is displayed, click Skip
to complete the setup. After software installation is
complete, remove any drive letter and try the
network setup of the Card Slot again using the
Canon IJ Network Tool. For details, refer to "Using
the Card Slot over a Network" in the User's Guide
on-screen manual.
• If "The Card Slot is already mapped as Network
Drive to this computer." is displayed, the Card Slot
is already set up. Click OK, then click Next.
6
When the Setup Completion dialog box
appears, click Finish.
The network connection between the machine and
the computer is now successfully established.
Sl'Jtt(JhalbeenCOflllleledCk:klFinilhj
ti)check lhetelWle$~,did< lV_SewpAM~~
7
When the Setup Complete screen appears,
click Next.
_.
setup Complete
n'(·~(:'u.'!~~<:r~·t)IHX";; l~ PloC\:(I:$JH"HN""[l;·u~", (~(>,
iN¢)t)!<>C~McHt'(:"'-"'1~!.~p
14