Table of Contents
Advertisement
E N G L I SH
•
Wear gloves when operating tool or
changing bits. Accessible metal parts on the
tool and bits may get extremely hot during
operation. Small bits of broken material may
damage bare hands.
•
Never lay the tool down until the bit has
come to a complete stop. Moving bits could
cause injury.
•
Do not strike jammed bits with a hammer
to dislodge them. Fragments of metal or
material chips could dislodge and cause injury.
•
Slightly worn chisels can be resharpened
by grinding.
•
Keep the power cord away from the
rotating bit. Do not wrap the cord around
any part of your body. An electric cord
wrapped around a spinning bit may cause
personal injury and loss of control.
Residual Risks
The following risks are inherent to the use of rotary
hammers:
–
injuries caused by touching the rotating parts
or hot parts of the tool.
In spite of the application of the relevant safety
regulations and the implementation of safety
devices, certain residual risks cannot be avoided.
These are:
–
Impairment of hearing .
–
Risk of squeezing fingers when changing the
accessory.
–
Health hazards caused by breathing dust
developed when working in concrete and/or
masonry.
Markings on Tool
DATE CODE POSITION (FIG. 1)
The Date Code (k), which also includesthe year of
manufacture, is printed into the housing.
Example:
2009 XX XX
Year of Manufacture
Package Contents
The package contains:
1 Heavy-duty rotary hammer
1 Side handle
1 Depth adjustment rod
1 Kitbox (K models only)
1 Instruction manual
•
Check for damage to the tool, parts or
accessories which may have occurred during
transport.
Take the time to thoroughly read and
•
understand this manual prior to operation.
6
Description (fig. 1)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
a.
Variable speed trigger switch
b.
Main handle
c.
Side handle
d.
Depth rod
e.
SDS Plus
®
chuck
f.
Mode selector button
g.
Mode selector
h.
Reversing lever
i.
Lock-on button
j.
Depth rod release button
INTENDED USE
These heavy-duty rotary hammers have been
designed for professional drilling and
hammerdrilling, screwdriving and light chipping.
DO NOT use under wet conditions or in presence
of flammable liquids or gases.
These rotary hammers are professional power
tools.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
Electrical Safety
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your D
WALT tool is double insulated in
E
accordance with EN 60745; therefore no
earth wire is required.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D
WALT service organization.
E
Using an Extension Cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
tool (see technical data).
The minimum conductor size is 1.5 mm
When using a cable reel, always unwind the cable
completely.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
2
.
Advertisement
Table of Contents
