How To Stop Your Pressure Washer; How To Use Accessory Tray; How To Use Spray Tips - Briggs & Stratton Victa Operator's Manual

How to Stop Your Pressure Washer

1. Release spray gun trigger and let engine idle for two
minutes.
2. Move throttle to SLOW
position.
3. ALWAYS point gun in a safe direction, press red button
and squeeze spray gun trigger to release retained high
water pressure.
WARNING The high pressure stream of water that
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
Spray gun traps high water pressure, even when engine is
stopped and water is disconnected, which could result in
serious injury.
• Keep high pressure hose connected to pump and spray gun
while system is pressurized.
• ALWAYS point spray gun in safe direction, press red button
and squeeze spray gun trigger to release high pressure, every
time you stop engine.

How to Use Accessory Tray

The unit is equipped with an accessory tray with places to
store your spray gun, nozzle extension and spray tips. There
is also a hook at the front of the accessory tray to hold your
high pressure hose.
NOTICE The extra hole in the tray is for storing a utility brush.
The extra clip in the tray is for storing a turbo nozzle. The
brush and turbo nozzle are NOT included with your pressure
washer. You can buy these items as optional accessories.
1. Place nozzle extension through hole on accessory tray,
as shown.
2. Place spray gun through hole on accessory tray on
right side of unit.
3. Insert multi–colored spray tips in spaces provided in
accessory tray.
4. Hang high pressure hose on hook attached to
accessory tray on front of tray, as shown.
14
position, then STOP

How to Use Spray Tips

The quick–connect on the nozzle extension allows you to
switch between three different quick connect spray tips.
Spray tips can be changed while pressure washer is running
once spray gun trigger lock is engaged. The spray tips vary
the spray pattern as shown.
Low Pressure
Black 25° Green
Use to apply
detergent
Follow these instructions to change spray tips:
1. Pull back collar on quick–connect and pull current
spray tip off. Store spray tips in holder provided on the
accessory tray.
WARNING The high pressure stream of water that
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
• NEVER exchange spray tips without the trigger lock being
engaged on the spray gun.
• DO NOT twist spray tips while spraying.
2. Select desired spray tip:
• For stubborn or hard to reach surface such as
second story surfaces, paint removal, oil stains, rust
removal or other stubborn substances (tar, gum,
grease, wax, etc.), select red maximum 0° spray tip.
• For most all purpose cleaning such as home siding,
brick patios, wood decks, driveways and sidewalks,
garage floors, etc., select green general 25° spray tip.
• For applying project specific detergents to help
break down stubborn dirt and grime on a variety of
surfaces, select black soap spray tip.
3. Pull back on collar, insert new spray tip and release collar.
Tug on spray tip to make sure it is securely in place.
Usage Tips
• For most effective cleaning, keep spray tip from 20 to
61 cm (8 to 24 in) away from cleaning surface.
• If you get spray tip too close, especially using a high
pressure spray tip, you may damage surface being
cleaned.
• DO NOT get closer than 15 cm (6 in) when cleaning tires.
High Pressure
0° Red
www.victa.com.au