How To Stop Your Pressure Washer; How To Use Accessory Tray - Briggs & Stratton Brute Operator's Manual

.
When starting engine, position yourself as recommended
and start engine according to instructions given in
engine operator's manual. Also seeoperating
instructions tag located on the pressure washer.
WARNING Starter cord kickback (rapid retraction) will
pull hand and arm toward engine faster than you
_a_ can let which could cause broken bones,
go
fractures, bruises, or sprains resulting in serious
injury.
, NEVERpull starter cord without first relieving spray gun
pressure,
When starting engine, pull cord slowly until resistance iSfelt
and then pull rapidly to avoid kickback,
After each starting attempt, where engine fails to run, always
point spray gun in safe direction, press red button and squeeze
spray gun trigger to releasehigh pressure,
Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury when spray gun kicks back.
,A WARNING The high pressure stream of water that
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
Spray gun traps high water pressure, even when engine is
stopped and water is disconnected, which could result in
serious injury.
DONOTallowCHILDREN t o operatepressure washer.
Keephigh pressure hoseconnected to pumpand spraygun
whilesystemis pressurized.
NEVER aimspraygun at people, a nimals,or plants.
DONOT securespraygun in openposition.
DONOT leavespraygun unattended whilemachine is running.
NEVER usea spraygun whichdoesnothavea triggerlockor
trigger guardin placeand in workingorder.
Alwaysbe certainspraygun,nozzles andaccessories a re
correctlyattached.
,a, WARNING Exhaust heat/gases could ignite
combustibles, structures or damage fuel
tank causing a fire, resulting in death,
serious injury and/or property damage.
Contact with muffler area could cause burns resulting in
serious injury.
DO NOTtouch hot parts and AVOID hot exhaust gases.
Allow equipment to cool before touching.
Keep at least 5 feet (1.5 m) of clearanceon ail sides of pressure
washer including overhead.
it is a violation of California PuNic Resource Code,Section
4442, to use or operate the engine on any forest-covered,
brush-covered, or grass-covered land unless the exhaust
system is equipped with a spark attester, as defined in Section
4442, maintained in effective working order. Other states or
federal jurisdictions may have similar laws.
Contact the original equipment manufacturer, retailer, or dealer
to obtain a spark attester designed for the exhaust system
installed on this engine.
Replacement parts must be the same and installed in the same
position as the original parts.
Hew to Step Your Pressure Washer
1. Releasespray gun trigger and let engine idle for two
minutes.
2. Turn
engine off according
to instructions
given
in
engine operator's
manual.
3. ALWAYS
point
gun in a safe
direction,
press red button
and squeeze spray gun
trigger
to release retained
high
water pressure.
,_, WARNING The high pressure stream of water that
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
Spray gun traps high water pressure, even when engine is
stopped and water is disconnected, which could result in
serious injury.
Keephigh pressure hoseconnected to pumpand spraygun
whilesystemis pressurized.
ALWAYS pointspraygun in safedirection,pressredbutton
andsqueeze sprayguntriggerto release highpressure, e very
time youstop engine.
Haw te Use Accessory Tray
The unit is equipped with an accessorytray with places to
store your spray gun, nozzle extension, high pressure hose
and quick connect spray tips.
1. Place nozzle extension
through
hob on accessory
tray
on left side of unit.
2. Place spray gun through hob on accessory tray on
right side of unit.
12 www.brutepewer.eem