How To Stop Your Pressure Washer; How To Usespray Tips - Briggs & Stratton Speed Clean Operator's Manual

How to Stop Your Pressure Washer
1. Releasespray gun trigger and let engine idle for two
minutes.
2. Push engine rocker switch to off position (0 or Off).
3. ALWAYS point gun in a safe direction, press red button
and squeezespray gun trigger to releaseretained high
water pressure.
,_kWARNING The high pressure stream of water that
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
Spray gun traps high water pressure, even when engine is
stopped and water is disconnected, which could result in
serious injury.
, Keephigh pressure hoseconnected to pumpand spraygun
whilesystemis pressurized.
* ALWAYSpointspraygun in safedirection,pressred button
andsqueeze sprayguntriggerto release highpressure, e very
time you stop engine.
Hew to Use Accessory Tray
The unit is equipped with an accessorytray with places to
store your spray gun, nozzle extension and spray tips. There
is also a hook at the front of the accessorytray to hold your
high pressure hose.
NOTICE The extra hob in the tray is for storing a utility brush.
The extra clip in the tray is for storing a turbo nozzle.The
brush and turbo nozzleare NOTincludedwith your pressure
washer.You can buy these items as optional accessories.
1. Place nozzle extension through hob on accessorytray,
as shown.
2. Place spray gun through hob on accessory tray on
right side of unit.
3. insert multi-colored spray tips in spaces provided in
accessory tray.
4. Hang high pressure hose on hook attached to
accessory tray on front of tray, as shown.
How to UseSpray Tips
The quick-connect on the nozzle extension allows you to
switch between three different quick connect spray tips.
Spray tips can be changed while pressure washer is running
once spray gun trigger lock is engaged.The spray tips vary
the spray pattern as shown.
Low Pressare
High Pressure
V
Black
Use to apply
detergent
0° Red
Fellow these instructionsto change spray tips:
1. Pull back collar on quick-connect and pull current
spray tip off. Store spray tips in holder provided on the
accessory tray.
2. Select desired spray tip:
A WARNING
.
The high pressure stream of water that
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
NEVER exchange spraytips withoutthetriggerlock being
engaged on the spraygun.
DONOT twist spraytips whilespraying.
, For general rinsing, ideal for most all purpose
cleaning such as home siding, brick patios, wood
decks, driveways and sidewalks, garage floors, etc.,
select green 25° spray tip.
, For maximum rinsing, for stubborn or hard to reach
surface such as second story surfaces, paint
removal, oil stains, rust removal or other stubborn
substances (tar, gum, grease, wax, etc.), select red
0° spray tip.
, To apply detergent, applies project specific cleaners
to help break down stubborn dirt and grime on a
variety of surfaces, select black detergent spray tip.
Pull back on collar, insert new spray tip and release
collar. Tug on spray tip to make sure it is securely in
place.
14 BR[GGSandSTRATTON.COM